Inside the Factory

One plant in Dongguan: sheet comes in one door, printed guards in vented cases leave through the other. Six stages, four inspection gates, and the tooling kept upstairs so a reorder does not need a new sample round.

120+ People in production, three shifts
300,000 pcs Pieces a month at full run
260+ moulds on file Shell tools maintained in-house
18 Moulding stations
What comes off the line

Six frames from a running order

Output photos rather than machine photos: the presses, trimming benches and case line are what the live walkthrough below is for.

Capacity

What the plant can take in a month

Six process lines, 120+ people across three shifts, and a monthly ceiling of 300,000 pcs. A 100-piece trial and a 30,000-piece team programme run on the same tools and the same inspection sheet, which is why scaling up does not change the product.

Moulding
18 stations — EVA and TPE sheet, steel tools, 3 shifts
Trimming
12 benches — Hand trim and edge buffing, thickness checked at three points
Pad printing
4 presses — One to four colours, plates cut in-house
Heat transfer
1 line — Full-colour wraps and photographic artwork
Case moulding
3 presses — Vented PP case, 82 × 72 × 32 mm, colour matched
Packing
2 lines — Polybag, case, sleeve or tuck box, 300 pcs per carton
Mouth guards laid out after moulding and printing
Quality control

Four gates, from sheet to sealed carton

Each gate has a number attached to it, because 'strict QC' is not something a buyer can check.

01

Incoming material

Each EVA or TPE lot arrives with its grade certificate. We check shore hardness and sheet thickness before it goes to the press, and keep the lot number against the batch.

Shore hardness ±3, thickness ±0.1 mm

02

In-process moulding

Wall thickness is measured at the front, mid-arch and rear every 50 pieces. A shell outside tolerance is pulled and the press is reset before the batch continues.

Wall ±0.2 mm, every 50 pcs

03

Print and assembly

Print registration is checked against the approved artwork, tether pull is tested on every batch, and the case hinge is opened and closed 20 times before packing.

Registration ±0.5 mm, tether 50 N

04

Final inspection

AQL 2.5 on the finished carton: shell, edge finish, colour against the signed sample, print, case and packing list. A photo report goes out before the carton is sealed.

AQL 2.5, photo report before shipping

Factory tour

A live walkthrough beats a video

Rather than a cut-together clip, we walk your line live on a video call: the press your shell runs on, the trimming bench, the print plate and the carton closing. It takes about fifteen minutes and you can ask the operator to measure a wall thickness while you watch.

  • The press and tool your shell actually runs on, not a show machine.
  • Wall thickness measured on demand at three points on the arch.
  • The print plate, the approved artwork and a finished shell side by side.
  • Carton, packing list and the photo report that ships with it.
Book a video tour

See the plant before you commit to a tool

A 15-minute video call, your shell on our press, and the inspection sheet in front of you.